Subject: Tracy & Bruce new apex seals.
From: ACRE
Date: 11/14/2003, 9:56 AM


Bulent Aliev wrote:> > > > >> > > > > What about the new 2mm apex seals
that Tracy demonstrated against> the> > > > > factory ones. Very impressive.> > >
D. Cain -/- Grand Prairie, TX -/- bdc196@comcast.net> > > BDC Motorsports -

For those of us that weren't at Shady Bend please tell us what was demonstrated
there reguarding the new apex seals. What was
done to show they are better than say, Hurley's and others including the new factory 2 piece?

Jim Brewer

Nothing was done along those lines to my knowledge. I may have missed
something however. Seems to me the only proof would be long term
testing in a working engine. Something like 2000 hours. It is hard to
simulate the environment an apex seals is forced to work in.

I was thinking about that on the way home from the hangar. If I were very wealthy
and I wanted to test apex seals I would set up Mazda engines as generator
sets and generate all the power for shop and home. I would use the waste heat
to heat hot water and heat the house and shop in the winter time. I would then
sell the excess power back to the power company.

Paul Lamar


Royce Wise wrote:

A break test was done to see how they would break in comparison to the
other seals.
The Hurley seal broke easily, but The new seals were very hard to break.
Looked like they were much stronger.
Royce

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.