Bulent Aliev wrote:> > > > >> > > > > What about the new 2mm apex
seals
that Tracy demonstrated against> the> > > > > factory ones. Very
impressive.> > >
D. Cain -/- Grand Prairie, TX -/- bdc196@comcast.net> > > BDC
Motorsports -
For those of us that weren't at Shady Bend please tell us what was
demonstrated
there reguarding the new apex seals. What was
done to show they are better than say, Hurley's and others including
the new factory 2 piece?
Jim Brewer
Nothing was done along those lines to my knowledge. I may have missed
something however. Seems to me the only proof would be long term
testing in a working engine. Something like 2000 hours. It is hard to
simulate the environment an apex seals is forced to work in.
I was thinking about that on the way home from the hangar. If I were
very wealthy
and I wanted to test apex seals I would set up Mazda engines as
generator
sets and generate all the power for shop and home. I would use the
waste heat
to heat hot water and heat the house and shop in the winter time. I
would then
sell the excess power back to the power company.
Paul Lamar
Royce Wise wrote:
A break test was done to see how they would break in comparison to the
other seals.
The Hurley seal broke easily, but The new seals were very hard to break.
Looked like they were much stronger.
Royce
The break test we did was very informal and was done without instrumentation
but it did show that it took much more force to break the new seal than the
Hurley.
The 700% stronger claim comes from a test we did when the force to break was
measured at 7 times the force required to break the Hurley.
Engine tests so far are in turbo 13B RX-7s running as much as 17 PSI boost.
Only about 8000 miles of testing so far but I am satisfied enough to put
them in my own engine.
Tracy Crook
Tracy,
I assume your seals are 2 mm.
I also assume you tested these against the 2 mm Hurley seals.
Are you planning on making 3 mm seals?
Even if some people do not consider 3 mm seals essential for
turbo engines sometimes the rotor slots are so worn it is necessary
to grind them out to 3 mm.
Have you tested your seals against the stock Mazda seals?
Can you send me a sketch of the test rig?
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.