Paul wrote:

We do need something fast as a lot of material is removed.
Especially on something large like a 3D contoured bell housing pattern.
Many many tool paths are involved to get the smooth surface finish

necessary.

You won't machine anything at 300 IPM, at least not with that spindle.
With your spindle turning 7000 RPM, 300IPM would be a feed per tooth of
0.020" on a two flute mill.  For an end mill in Alloy you are looking at a
max of about 0.011", less for a ball.

With a 1/4" ball end mill, you would be looking at about 548 SFM, which is a
low for alloy .

Drive a 1/4" ball though foam at 0.020" feed and 548 SFM, and you will just
tear it apart, not cut.

In practice, you will machine far below the rapid speeds of the machine, so
whether the machine can do 300 IPM rapids, or only 120 IPM rapids won't make
much difference in run time.

To do high speed machine you would need a much faster spindle, and an
effective cooling system.

Regards,
Mark

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.