Subject: Tracy & Bruce new apex seals.
From: ACRE
Date: 11/15/2003, 11:11 AM


The break test we did was very informal and was done without
instrumentation
but it did show that it took much more force to break the new seal than
the
Hurley.

The 700% stronger claim comes from a test we did when the force to break
was
measured at 7 times the force required to break the Hurley.
Engine tests so far are in turbo 13B RX-7s running as much as 17 PSI
boost.
Only about 8000 miles of testing so far but I am satisfied enough to put
them in my own engine.

Tracy Crook

Tracy,
I assume your seals are 2 mm.
I also assume you tested these against the 2 mm Hurley seals.
Are you planning on making 3 mm seals?

Even if some people do not consider 3 mm seals essential for
turbo engines sometimes the rotor slots are so worn it is necessary
to grind them out to 3 mm.

Have you tested your seals against the stock Mazda seals?

Can you send me a sketch of the test rig?

Paul Lamar

Paul or Tracy,
What are they made of and will it wear the housings more quickly!?
George (down under)

You read my mind George. I was about to ask Tracy what was the Rockwell hardness
of his seals compared to the Hurley and the stock Mazda two piece seals?
Mazda heats the wear edge of the stock seals with a laser and then chills
them in liquid nitrogen.

Also what is the smoothness or surface texture in terms of R1 micro inches.
Here is some background on the importance of the surface texture.

Paul Lamar

IMHO the perfect apex seal would be super smooth to reduce chatter
inducing friction yet have damping in the slot. It would also
require sufficient high temp lube (over 500 F) to keep it out of 
contact with the rotor housing. It is interesting that Mazda now 
uses two oil injectors in the RX8 engine. One on each end of the apex 
seal with the side exhaust ports. Previously one injector was used at the 
center of the apex seal when peripheral exhaust ports were used. 
In that case the center of the apex seal was running over 500 F
at wide open throttle.  Probably due to the exhaust gases squirting
bye the apex seal just as the exhaust port opened. 

The ideal seal would weigh nothing so it could exactly follow the 
contours of the rotor housing at high speed.

Least I forget the ideal apex seal should not shatter under detonation.

Here are some other factors relevant to the manufacturing of apex seals.

As you can see from these charts the BSFC at light load (typical of 
automotive use) depends on excellent sealing.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.