Subject: Griffin Oil cooler pressure test
From: ACRE
Date: 11/22/2003, 11:56 AM

Al Gietzen wrote:

I had a specified a pressure of 125 psi on the custom design oil cooler 
that Griffin built for me.  I asked them about their
pressure testing, but it was a year after they built it and 
the engineer on the job had left, and  they could not find any info
in the file.  Just to double check, I pressure tested it - cycled it 4 times to 125 psi. 
Everything is just fine.

It has rather wide flat tubes (3.35"); and I was under the false 
impression that they were internally brazed to turbulators on
the inside to withstand the pressure.  They used to make them that 
way, as did Earls and others.  I took a careful look into the
end fitting and found that they are extruded tubes that have 
internal fins axial connecting the two walls at about a ¼" spacing,
and a couple of smaller fins extending part way into the channel 
in between.  Makes for good pressure strength and good heat
transfer.

Going back to my correspondence with Griffin I found that they 
did mention extruded tubes, but gave no description.

Al

Al, wasn't Griffin the supplier of the oil cooler that failed in 
Chuck Harberts turbo 3 rotor? Perhaps you have a different one. 
What does the box it came in look like?
Chuck's oil cooler came in a box that had a yellowish appearance.

Paul Lamar

The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.