Al Gietzen wrote:
I had a specified a pressure of 125 psi on the custom design oil cooler
that Griffin built for me. I asked them about their
pressure testing, but it was a year after they built it and
the engineer on the job had left, and they could not find any info
in the file. Just to double check, I pressure tested it - cycled it 4 times to 125 psi.
Everything is just fine.
It has rather wide flat tubes (3.35"); and I was under the false
impression that they were internally brazed to turbulators on
the inside to withstand the pressure. They used to make them that
way, as did Earls and others. I took a careful look into the
end fitting and found that they are extruded tubes that have
internal fins axial connecting the two walls at about a ¼" spacing,
and a couple of smaller fins extending part way into the channel
in between. Makes for good pressure strength and good heat
transfer.
Going back to my correspondence with Griffin I found that they
did mention extruded tubes, but gave no description.
Al
Al, wasn't Griffin the supplier of the oil cooler that failed in
Chuck Harberts turbo 3 rotor? Perhaps you have a different one.
What does the box it came in look like?
Chuck's oil cooler came in a box that had a yellowish appearance.
Paul Lamar
Sorry Al. I forgot to attach the picture you sent. Cancel my last message.
This oil cooler looks entirely different than Chuck Harberts's.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.