Subject: Turbo 3 rotor flying boat crash.
From: ACRE
Date: 11/25/2003, 11:16 AM


NTSB Identification: LAX03LA267
                                         14 CFR Part 91: General Aviation
                                Accident occurred Thursday, August
28, 2003 in Tracy, CA                                    Aircraft:
Petz Flying Boat, registration: N1216Z
                Injuries: 1 Fatal.

 This is preliminary information, subject to change, and may contain
errors. Any errors in this report will be corrected when the final
report has been completed.

On August 28, 2003, approximately 0815 Pacific daylight time, an
experimental Petz Flying Boat, N1216Z, lost control in flight and
collided with terrain approximately 660 feet south of Tracy
Municipal Airport, Tracy, California. The airplane was operated by
the private pilot/owner under the provisions of 14 CFR Part 91. The
pilot, the sole occupant, sustained fatal injuries, and the airplane
was destroyed. Visual meteorological conditions prevailed and a
flight plan had not been filed. The flight originated at New
Jerusalem Airport about 0835.

A Federal Aviation Administration inspector at the scene reported to
the Safety Board investigator that the airplane wreckage was found
in a rock quarry gravel pit and was completely consumed by fire.

Family members reported that they believed that this was the first
flight of the airplane, which was designed and built by the pilot.


*****************************************************************************
*

Surely the local EAA guys know something about it.
Anybody have any further information on this airplane.
Bill Jepson or anybody else in that area.
Can you do a little detective work for me on this?

Rumor and supposition has it the exhaust melted the composite prop.
So make sure your pusher engine is not dumping the 1750 F exhaust
right at the prop.

Paul Lamar

Perry Mick wrote:

That's bizarre, you know my installation, the exhaust exits in front of my
composite prop. I have no muffler, just the stock exhaust manifold and a
short pipe. Prop has been fine for 430 hours, gets some soot on it but
doesn't get warm because of all the airflow over it. If the blade was
sitting still in front of the exhaust I could see it failing!

Perry

Perhaps it is the increased volume of heat from a turbo 3 rotor Perry.

I don't really know anything about this accident. In fact I am not
sure the engine or prop even failed. The guy may have merely spun in
due to defective aerodynamic design, aft CG  or just a plain old stall/spin.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.