I don't really know anything about this accident. In fact I am not
sure the engine or prop even failed. The guy may have merely spun in
due to defective aerodynamic design, aft CG or just a plain old stall/spin.
Once again, aviation in general has to pay for the pig ignorance of one
selfish individual. This is what leads to every design
having to be submitted to some idiot government employee for approval
before you build it. Not before you fly it.
The high thrustlines tends to pitch up with a sudden power loss. Add
an out of aft CG and a sub par pilot, and the chances of a
successful first flight approach zero.
The bearing and rotor damage sounds like low or no oil pressure.
Nothing to do at all with the external oil metering system.
This kind of failure produces a very sudden power loss. It is
not a reduction of 50% on a two rotor. A very persistent driver
can bring the car back to the pits on the maybe 25 HP left from
one poorly sealing rotor dragging the rest of the dead engine
and the car.
The amount of oil that may be mixed with the fuel to lubricate
the apex and side seals has little affect on the spark plugs
fouling unless it is not a synthetic. (this with MSDs).
Before we knew about synthetic oils, we ran the same Valvoline
50 WT. in the fuel. We changed a lot of spark plugs. Even with 8
oz. of synthetic Redline 2 cycle in 5 gallons of fuel, we get a
season out of one set of plugs.
What a shame it is that this guy would not listen, for whatever
reason. Perhaps a great design has slipped away, needing only a
few more hours on the ground, before that flight.
I hate to compliment the government guys at all, but they did
the only thing they could think of at the time. It was not their
fault that the Mazda mechanic(s) didn't know anything about Mazda
engines. They only replace things, not fix them. It may have
been the first time any of them had seen the inside of an engine.
And almost certainly they had never seen a three rotor at all.
Lynn E. Hanover (retired government employee)
I think you are mixing up two different crashes Lynn. The first was a
13B loss of oil pressure April 2002. The second, turbo three rotor, happened
in Aug. and we have no idea what so ever what caused the crash.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.