Ed Klepeis,

Can you modify this one pass  Howe rad to a two pass for me?
The tough part is welding the partition between the tubes.

The in and out necks are 1-1/2 inch hose barbs.
The rad will be horizontally mounted under the engine so the barbs
should be all the way over to the right in each section 
to simplify the water pump plumbing.

The front end needs a 30 degree chamfer on both ends to fit under the
cowl better.

I'll do a 3D for you in a day or so.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.