Good Pics Paul. I wonder if this can be adapted to Tracy's system?
I'd love to get rid of the distributor remnants on the 20B!
Bill Jepson
Yes I am sure it can be. Might take a bit of programming on Tracy's
part.
You might look into this system which uses two pulses already
supported by Tracy's computer. Same as the third gen. I have used
something similar for 20 years and hundreds of systems.
These photo transistors have rise times on the order of 10 usec.
Paul Lamar
"Kevin R. Walsh" wrote:
No! The optical bits are a BAD idea for ignition systems. I installed
an optical triggered electronic ignition system on my Austin Healey
Sprite and had an ignition failure due to the pickup being blided by
dirt/oil. I've been recently doing all of the design work on a new
ignition system for my motorcycles, and I am currently using IGBTs to
do the coil switching and Hall effect sensors for crank position. Hall
effect sensors are just as fast and can operate in dirty environments.
If you must have finer resolution to the position, use a Hall effect
for the once per rev signal and an optical for the finer position, as
long as your processor (a PIC18 in my case) can deal with the loss of
the optical sensor. It takes a bit more software, but it should be
MUCH more robust that way.
I used them for many years in high dust environments and never had any problems
but that is a concern. I think the best place for it is up above the e-shaft
between the block and the ring gear. Fairly clean up there.
Easily inspected too.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.