Subject: EDM Arc method of removing roll pins.
From: ACRE
Date: 12/2/2003, 12:16 AM


If you are really good with small amperage arc welding,
you can spot weld a small arc rod to the pin, and use it
as leverage.
The heat from the arc relaxes a some of the tension, and
helps the removal.
I used that famous duct tape with a small hole in it to
shield the other parts from arc spatter.
I did this twice successfuly, not sure of how well it
might work here.
Archie


-American Flyer wrote:

There's a guy on eBay who sells plans for a broken stud remover which 
arcs away the stud. It might work for roll pins too.

http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&item=2577058142&category=11774

This guy's contraption looks very elaborate. It could probably be 
done much simpler if you were only looking to use it occasionally.

Harrison Young

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.