Subject: Mag pick up and toothed ring.
From: ACRE
Date: 12/2/2003, 12:18 AM


I used them for many years in high dust environments and never had any
problems
but that is a concern. I think the best place for it is up above the
e-shaft
between the block and the ring gear. Fairly clean up there.
Easily inspected too.

Paul Lamar

Paul,
Excuse my ignorance what is a hall effect sensor - electro magnetic !?
George (down under)

Hall effect is Hall Effect :) I can look it up but I can't explain
it without looking it up :) 

I think it requires a moving magnet where the
regular Mazda mag ignition pickup is just a lot of small wire wound around a
nail. All it requires is a discontinuity in a rotating steel or iron disk like
a starter ring gear tooth. The regular mag pick up puts out a rather noisy or dirty 
signal so it requires some electronic conditioning to form a nice clean pulse.

A Hall effect sensor on the other hand is a solid state device with integrated
electronics (transistors) so it puts out a nice clean pulse from the get go.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.