marc wrote:

Paul,
I found a lot of an/metric adaptors at Parker Hanaflin (sp??) shops

that

make up hydraulic hoses. They can get them for you if they don't

have

them in that shop, they said (2 years ago) that they bought a line
making those adaptors. Look in the yellow pages. I used those

adaptors

on my tt 13B oil coolers (fd type) to change to an lines.
[Marc Wiese]

Thanks for the tip. I'll look into it.
Did you use dash 10 on your oil lines Marc or dash 8?

Paul Lamar

It's been awhile, I think 8. Also those FD coolers have a strange pitch,
but PH had the metric thread adaptors to fit the stock coolers.
[Marc Wiese]

MacMaster Carr carries some too. The 18 MM 1.5 to dash 8 they have in female only.
They have the 16 mm 1.5 to dash 8 in male. They are about $12 each.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.