The coot plans call for a solid glass hull with wood bulkheads.
The way I made hull with the foam core cut 20 lbs from the hull and
made it much stronger and I made the bulkheads from foam core also
which cut some weight.
I will send you some photos of the construction of my hull, also I
am about start building my new composite wings and I will send you
the letters and photos that I send into the coot group of that
construction as it goes along, I hope to have the new wings on by
spring.
I was also advised by others to use 1/4 inch foam and I looked at
the way others were built and in fact I saw some others that used
foam as thin as 3/16 inch.
Yes I had to buy the coot molds from Molt Taylor to build my first
coot but I am getting out of doing the glass work myself and going to
farm it out except for my own projects.
Ken
Thanks ken you have confirmed my own beliefs,
BTW I believe the strength process is multiplied by 4 ever time you double
the thickness of the distance between glass layers i.e. in this case the
foam.
People see this and tend to think, 'Oh good I'll go to 1/2" '- whereas
thicker foam can lead to other construction problems/limitations, where the
1/4" is more often, more than suitable. For instance 1/4" will bend around
corners and do complex shapes, where with 1/2" you won't have a hope in
hell!!
However 1/2" is excellent if you wish to use it to retain a fairly rigid
straight panel before glassing.
Again glassing one side 1/4" bends nicely, whereas again, you won't have a
hope in hell of bending the 1/2" much at all.
George
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.