Subject: Buying used RX-7, any gotchas?
From: ACRE
Date: 12/7/2003, 9:21 PM

rvz wrote:

I've found a used 86-or-so RX-7 for $500, just wanted a rotary to play
with and learn on while I'm building the plane.  This engine may or may
not end up in a plane, as I'll need a 3 rotor, so I'm buying this one more
for the experience  Story is it was parked running, battery went dead,
now it won't start.  Since this is my first rotary, I have to ask a couple
of stupid questions.  I'm assuming a tune-up will probably get it running.
Any known computer/dead battery wierdness I should be aware of that
might keep it from running?  Also, is it safe to give a rotary a shot of
starting fluid for encouragement?  Any other thoughts appreciated.

Thanks,
Bob

Snap it up :) 

Suck any accumulated fluid out of the bottom of the rotor housing with a 
squeeze bottle and small plastic tube inserted into the lower spark plug 
hole. Set the engine to 30 degrees after top dead center to do the front 
rotor and then about 210 degrees after top dead center to do the rear rotor. 
Very important.

Once this is done squirt a little auto tx fluid in to each rotor and turn 
the engine over with the fuse to the electric fuel pump removed. Let it sit 
over night. Check the compression by using an ordinary compression gage with 
the schrader valve removed. You should get three equal pressure pulses in a 
row for each rotor as the engine is rotated several times with the starter. 
Install new spark plugs. Replace the fuse in the fuel pump circuit.
If you are lucky and assuming the compression is OK the engine should now restart. 

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.