rvz wrote:
I've found a used 86-or-so RX-7 for $500, just wanted a rotary to play
with and learn on while I'm building the plane. This engine may or
may
not end up in a plane, as I'll need a 3 rotor, so I'm buying this one
more
for the experience Story is it was parked running, battery went dead,
now it won't start. Since this is my first rotary, I have to ask a
couple
of stupid questions. I'm assuming a tune-up will probably get it
running.
Any known computer/dead battery wierdness I should be aware of that
might keep it from running? Also, is it safe to give a rotary a shot
of
starting fluid for encouragement? Any other thoughts appreciated.
Thanks,
Bob
Snap it up :)
Suck any accumulated fluid out of the bottom of the rotor housing with a
squeeze bottle and small plastic tube inserted into the lower spark plug
hole. Set the engine to 30 degrees after top dead center to do the front
rotor and then about 210 degrees after top dead center to do the rear
rotor.
Very important.
Once this is done squirt a little auto tx fluid in to each rotor and
turn
the engine over with the fuse to the electric fuel pump removed. Let it
sit
over night. Check the compression by using an ordinary compression gage
with
the schrader valve removed. You should get three equal pressure pulses
in a
row for each rotor as the engine is rotated several times with the
starter.
Install new spark plugs. Replace the fuse in the fuel pump circuit.
If you are lucky and assuming the compression is OK the engine should
now restart.
Paul Lamar
Bob,
I would guess that the odds are greater than 50% that this engine is
dead because the internals are all gunked up with carbon deposits and
other stuff. This engine will most likely require a teardown to clean
the insides. This will restore movement to the apex seals (and the
other rotor seals as well) so compression will be restored. The only
hard part is dealing with all the Mazda smog junk. Cost is only about
$100 for gaskets unless something is broke inside the engine, which
really isn't very likely.
Ken Powell
Ken does that $100 price include all new O-rings?
One of these days someone ought to take an engine out of one of these
cheap cars and mount it plugs down. Then fill it up with carb cleaner
or some other cleaning solvent, let it sit for awhile and see if it will
get the gunk out. Repeat as necessary. Worth a try.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.