Subject: Buying used RX-7, any gotchas?
From: ACRE
Date: 12/8/2003, 4:14 PM


rvz wrote:

I've found a used 86-or-so RX-7 for $500, just
wanted a rotary to play
with and learn on while I'm building the plane.
This engine may or
may
not end up in a plane, as I'll need a 3 rotor, so
I'm buying this one
more
for the experience  Story is it was parked running,
battery went dead,
now it won't start.  Since this is my first rotary,
I have to ask a
couple
of stupid questions.  I'm assuming a tune-up will
probably get it
running.
Any known computer/dead battery wierdness I should
be aware of that
might keep it from running?  Also, is it safe to
give a rotary a shot
of
starting fluid for encouragement?  Any other
thoughts appreciated.

Thanks,
Bob

Snap it up :)

Suck any accumulated fluid out of the bottom of the
rotor housing with a

squeeze bottle and small plastic tube inserted into
the lower spark plug

hole. Set the engine to 30 degrees after top dead
center to do the front

rotor and then about 210 degrees after top dead center
to do the rear
rotor.
Very important.

Once this is done squirt a little auto tx fluid in to
each rotor and
turn
the engine over with the fuse to the electric fuel
pump removed. Let it
sit
over night. Check the compression by using an ordinary
compression gage
with
the schrader valve removed. You should get three equal
pressure pulses
in a
row for each rotor as the engine is rotated several
times with the
starter.
Install new spark plugs. Replace the fuse in the fuel
pump circuit.
If you are lucky and assuming the compression is OK
the engine should
now restart.

Paul Lamar

Bob,
I would guess that the odds are greater than 50% that
this engine is
dead because the internals are all gunked up with
carbon deposits and
other stuff.  This engine will most likely require a
teardown to clean
the insides.  This will restore movement to the apex
seals (and the
other rotor seals as well) so compression will be
restored.  The only
hard part is dealing with all the Mazda smog junk.
Cost is only about
$100 for gaskets unless something is broke inside the
engine, which
really isn't very likely.

Ken Powell


Ken does that $100 price include all new O-rings?

One of these days someone ought to take an engine out of
one of these
cheap cars and mount it plugs down. Then fill it up with
carb cleaner
or some other cleaning solvent, let it sit for awhile and
see if it will
get the gunk out. Repeat as necessary. Worth a try.

Paul Lamar

Been done Paul. They run the FD on dyno or with rear
wheels in the air, letting ATF run in the engine to clean
it out. Sort of a decarbonizing process that raises
compression, esp on the AT models. Also has anyone tried
that commercial decarbonizing done at some of the shops?
They run something else thru......I have even heard water
being used.
Marc Wiese

I am talking about an engine that is so cruded up it does not run.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.