Subject: Resonance- was PSRU / answer on Seal set]
From: ACRE
Date: 12/9/2003, 10:11 AM


 > > >>  Sorry to disagree Ken, but on our best drag bikes we use
lightened
 > >>crankshafts
 > >>  and clutch baskets. Inertia is inertia, rotational inertia
is the
 > >>same. It will
 > >>  take you longer to accellerate the heavy flywheel no matter
what
 > >>else happens.
 > >> [snip]
 > >>  Bill Jepson

 An acquaintance of mine who manages an IRL team said something I
found
 extremely interesting while showing me some stuff.  I was asking
why they
 use lighter suspension components on less demanding tracks since
the
 difference in weight is extremely small and the final car weight
will be
 exactly the same anyway.  He said they have found that over
building
 components tends to lower reliability.

 Keep in mind, I don't speak for him and I'm not a P. Eng.

 Lightened flywheels on two stroke drag outboard engines do help
performance
 but only in a barely measurable way.  To go from a stock aluminum
flywheel
 to the lightest flywheel that will hold a ring gear will only make
about a
 1/10th second difference over a quarter mile.  The flywheels are
lightened
 to raise their resonant frequency.  Many stock OMC V6 outboards
have a
 resonance at 6200~6400 RPM and they will shear cranks if propped
to top out
 at that engine speed unless the flywheel is lightened to raise
that
 resonance above WOT engine speed.

 Lightened pistons and rods can help reliability also but I would
tend to
 think that roughly anything that reduces vibration, lighter or
heavier,
 will be beneficial to reliability.

 My $0.02,

 Tom

    One thing that Atkins said is that there is bad resonant vibration
in the 13b at 6200 rpm and try to stay out of that zone so I try to
run at 6000 or 6500 but in the early days I didn't know that and may
have been beating up the dampers in that zone.
  He also said that the 20b doesn't have that vibration zone.

   Ken

That is nonsense Ken. I have owned six rotary engine powered cars, read
all the
engineering information published on the rotary engine for the past 35
years
and there are no resonant zones in any RPM range up to 11,000 RPM.  One
can
learn how to overhaul a rotary engine and overhaul thousands without
understanding the physics and kinematics involved in its operation.

Paul Lamar

Perhaps the condition Atkins was feeling was related to his particular
prop/psru combination.  Also, I looked at an old Mazdatrix catalog and
the gasket set did contain the water orings as well as the oil control
orings ($105 as of 1999).

Ken Powell


 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.