> > Bob,
I would guess that the odds are greater than 50% that this engine
is
dead because the internals are all gunked up with carbon deposits
and
other stuff. This engine will most likely require a teardown to
clean
the insides. This will restore movement to the apex seals (and
the
other rotor seals as well) so compression will be restored. The
only
hard part is dealing with all the Mazda smog junk. Cost is only
about
$100 for gaskets unless something is broke inside the engine,
which
really isn't very likely.
Ken Powell
Ken does that $100 price include all new O-rings?
One of these days someone ought to take an engine out of one of these
cheap cars and mount it plugs down. Then fill it up with carb cleaner
or some other cleaning solvent, let it sit for awhile and see if it
will
get the gunk out. Repeat as necessary. Worth a try.
Paul Lamar
Andy Hecker wrote:
Paul,
This is exactly the type of cleaning that AMSOIL's Power Foam was
formulated for. It's a heavy duty cleaner and degreaser that foams
and
expands when dispensed. This is the stuff I sent to Royce to try for
rotor
cleaning.
I just cleaned my upper piston ring grooves on my VW turbo diesel
the
exact way you just described - filled the cylinders with foam and let
it
soak thru to de-carbon/de-coke the ring grooves.
The usual use for the product is to spray it into the intake of a
running
engine until the engine quits and just let it soak. It really does an
excellent job.
Andy
ahecker@satx.rr.com
- I don't see how foam is going to get into apex seal slots.
-Paul Lamar
Paul,
A conventional liquid cleaner, if launched into a cylinder thru a
straw,
will head in a generally straight line in a mildly expanding cone shape
not
unlike a very bad fuel injector. The only way to get the cleaner on all
of
the surfaces is to hope it splashes enough, move the engine around, or
completely fill the cylinder with liquid.
The PowerFoam comes out of the spray can and expands quickly, coating
everything it touches. It starts to turn back into liquid within 5
seconds
or so and soaks into/dissolves whatever crud it's touched. It looks
almost
like expanding foam insulation when it first comes out of the can and
really
clings.
Let me know of you want to try it. I'll drop you a can.
Andy
I don't want to try it. It is up to the seller to prove what ever he is
selling works. Science is based on the repeatable experiment. Get a rotary
engine that won't run because of low compression. Rotate it so the plugs
are down. Fill it with foam. Let is sit. Flush the foam out with a
solvent.
Squirt a small amount of oil in the engine. Check the compression. If the
compression is good put in a new set of plugs. Try and start the engine.
Report back.
Paul Lamar
Paul Carey wrote:
Paul
I tried the Marvel Mystery Oil decarbonising on my 20B and it worked well.
Spray the oil into each housing, while turning the engine to each rotor
flank.
Each day for a week I turned the engine by hand, spraying more oil in.
First start up is smokey, but the penetrating affect of this oil is truly
amazing.
PC
Paul Carey LAME, MC
Aero Management - aviation consultants.
www.aeromanagement.com.au
(08) 9371 5205 0418 959 892
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.