Subject: Blown 3 Rotor engine torsional stiffness.
From: ACRE
Date: 12/18/2003, 12:58 AM


A four cylinder mag on a three rotor?? Vance

Good question. How does that work Paul?

Paul Lamar.

Paul Carey wrote:

Paul and Vance

The magneto is a 6 cylinder Bendix - a four pole mag geared 2/3 inside for
six cylinders.
My gilmer drive is 2/3 to get the right rpm, and I run two leads to each
plug.
I have charts etc on how I worked it out if you want.

I have installed lots more dowells in the engine, but Ibarra and Signorelli
and other hard
hitting rotor drag cars still have the twisting problem - I believe it
cracks the rear housing.

PC

I would be interested in the charts.

OK a big box on the bottom will do the job. You should use carbon fiber
however as it has a higher shear modules of elasticity to weight ratio
than either aluminum or steel. Both of which are the same BTW.

Giving it a little more thought you kind of have limited room under the
engine for a big box.

How about a large properly triangulated space frame using steel tubing
surrounding the entire engine? Front and rear motor plates. That would
give you a front chassis structure to hang the front suspension off and
give you service access to the engine.

I'll do a 3D of what I am talking about.

Paul Lamar

I think you can get the idea form this 3D. Larger tubing of course.
I would say around one inch ought to be about right.
If you are using a steel body the inner fender wells can be used
as two sides of the six sided box. All six sides MUST be triangulated
however. Some tubes can be bolted in for access.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.