"Bruce E. Calkins" wrote:

Dear Mr. Lamar:

As you are aware, Moller International/Freedom Motors has been involved in
the development and production of a limited number of rotary engines for
many years.  To support these activities we acquired some of GM's excess
rotary engine tooling, specifically a trochoid grinder and two side seal
slot cutters.  But we have been unable to locate any of the additional
equipment produced by Gleason in the early 1970's for GM and other

companies

with rotary production plans.

Are you aware of the location and availability of any rotary engine
production equipment?  We are specifically interested acquiring the

Gleason

Rotary Milling machine, as well as any additional side seal cutters. Our
production costs for the Rotapower 650 & 1300 are anticipated to remain
relatively high until we can equip our manufacturing facility in Minnesota
with machines that have higher potential throughput.

Any assistance you could provide in helping us locate this equipment would
be greatly appreciated.

Regards,

Bruce E. Calkins
General Manager
Moller International
(530) 756-5086
www.moller.com

Not yet but somebody on here might respond.
Have you tried RPI?

Paul Lamar

"Bruce E. Calkins" wrote:

Yes, Dr. Moller has spoken with them, but wanted to continue to pursue this
through as many channels as possible.

BTW, I am not receiving the ACRE newsletter any longer, so if you get a
positive response on this issue could you forward it to me?

Thanks,
Bruce

Sure Bruce.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.