Jerry Hey wrote:

Paul,  as  you would expect,  253MA is fairly  expensive in sheet
form.
  It costs $5.59 per lb.  The thinnest material readily available is
.059."  A  48" x 96" sheet is 99 lbs.   One sheet  would make  a
number
of  complete  exhaust systems.   One could limit the use of 253MA to
just the header.  The rest of the system could be 321.  It would last
forever.   Once  you accept making the exhaust from sheet, the square
tube design is easier to fabricate than the round one, I think.

   We need to develop the ability to roll sheet into round exhaust
tubes
including sweeps.    I have seen  pictures of some beautiful old Indy
race cars  with hand formed stainless exhausts that are works of art.
Any one out there know how to do this? Ed?

   I could not get a price on tubing which has to be special ordered.
Jerry

What happened to the original report Subject: High Temp SS?  If you did
not get it, I will send again.     Perhaps it was too big.  Three
attachments one of which was a PDF.   Jerry

I did not get a chance to send it out before I had to leave.
It has gone out now. You are right the pdf is too big.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.