Jerry Hey wrote:

Paul

I finally have learned how to build a square tube exhaust system
that
wraps and curves anyway I want.  I am going to build another MM
(number
4) for my airplane using the wide MMP.  The exhaust system will fit
inside the mount. It will lay beside the wedge oil  pan but far
enough
off to allow for heat shielding.  It can be built out of .063 321
sheet
for around $250 (materials) which I think is not bad.  If the 2000
degree SS turns out to be for real, thinner sheet may be possible.

  Ed Klepies and I will be getting together after the holidays. His
airport is less than 2 Tailwind  hours away.

  Shop wiring will be finished today.  Hook up before the end of the
month. There is much to do to make the shop fully  functional, but I
will be working on the rotary installation as soon as the power is
turned on.

  Jerry

Jerry,
Is this a VAM style muffler?
George (down under)

No,  I don't  have room for a VAM.  Jerry

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.