Subject: Oil Pressure, Temperature, & Re-Drive feed
From: ACRE
Date: 12/26/2003, 11:33 AM


"Joe Hull (Pilgrim Technologies)" wrote:

 I'd like to put an oil pressure, temperature, and re-drive oil
feed line
 into the stock hole under the oil filter (1986 13B).
 Anyone know:

 1. The size of the hole in metric - It's close to 1/8 NPT so I'm
 guessing it's M-16 x 1.5?

 2. Got any leads on a Tee with male metric on one thru side, 1/8
NPT on
 the other thru side (for pressure/temperature), and Dash-6 male
tube in
 the middle (for feeding the redrive)?

   Male Metric M-16 x 1.5 ?
     |
     |
     ------  Dash 6 to 3/8 flared tube
     |
     |
 1/8 NPT female

 Joe Hull
 Cozy MkIV #991 (working on Engine & Cowling)
 http://www.maddyhome.com/canardpages/pages/JoeHull/index.html

It is definitely a tapered thread. Not M16 1.5 which is straight.
Probably
a metric pipe thread if there is such a thing.

I am thinking of taping mine out to 1/8 NPT or perhaps 1/4 NPT.
I just want to use a simple pressure gage.

Search Google for metric hose fittings. Klause showed me a catalog
so they are definitely out there. I'll try to get the phone number
again. They may not have a web site.

Paul Lamar

   I cut off a stock oil sender unit and tap it out to 1/8 pipe to
make an adapter.

   Ken

Sounds like a good plan Ken.

BTW got the blades. they look fine for the dyno. Will bond back on
the delaminated parts. Thanks a bunch. Merry Christmas.

Paul Lamar

-"Joe Hull (Pilgrim Technologies)" wrote:

Summary findings (for those who save and search old emails):

I work a couple miles from Hayes Rotary Engineering in Redmond, WA so I
went up there last week and was asking them about this same issue and he
handed me an old oil pressure/temp sender unit and said "you might try
cutting it off and tapping it out".  It sounds like that is common
practice.

The other advice I got off this email list was to blow compressed air
into the oil inlet at the bottom of the engine while I tap out the
existing hole to 1/8th NPT. I'm a little concerned about metal chips in
the engine with this approach.

If I pursue the adapter route - this company http://www.goodridge.net/
seems to have the most comprehensive AN-metric adapters - although I'm
still researching that avenue.

Thanx,
Joe Hull
Cozy MkIV #991 (working on Engine & Cowling)
http://www.maddyhome.com/canardpages/pages/JoeHull/index.html

Good idea if the filter is off the chips will come out of the
lower filter hole.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.