My only concern with the sealant idea instead of the o-ring plan is

that if you get any of the sealant to squeeze out on the
inside of the assembly and it later breaks off where will
it go?  If the filter catches it all well and good  if it goes
downstream into the engine the results may be more ...well
interesting is perhaps one way of putting it :-)

Bryan in

Princeton B.C.

Very good point. If you do this as I plan to do, you can look down 
to where the goo would squeeze out and clean it up before you proceed
to put your fittings into the relocation plate. At least you can with my adapter plate.

Brian Trubee

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.