Hi, Paul.....I finally got the electronics wired on my 13b, and the starter 
turns the engine over fine. I should have my
radiator and oil cooler installed within a week or two.  
Then, the final thing I will need is a muffler, then I can run this
thing and scare the neighbors.

       I was considering using the exhaust plate that I purchased 
from Mazdratrix (I believe that's where I purchased it, I'll
have to look at receipts), and having two 90 degree stainless 
steel tubes welded into the existing holes on the plate.  From
there, I need to go to a two-into one adapter, then to 
stainless steel flex pipe, and then I could mount a muffler to that.  It
will be much easier if and when the VAM  muffler is available, of course.

      Any suggestions for a source for a two-into one adapter?   
Unfortunately, I will be at the mercy of the local welders, as
welding is not in my job description.   Of course, I might be 
able to fabricate one with materials that are more familiar to
me.....Would you suggest Oak or Pine?  Thanks for any and all 
suggestions.  Paul Conner, Mobile, AL

Try Burns Stainless catalog page 8 for two into one. www.burnsstainless.com

Paul Lamar

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.