Hi, Paul.....I am almost finished with the wiring for my ECU on my 13B.
A few more other connections, and it should be ready to run it and begin
 taxi testing. Hopefully within a couple of weeks?   My final obstacle
is the muffler.

I was looking at the inconel exhaust that Racing Beat
made, that is shown on your website, and a picture is also attached
to this e-mail.  I was wondering how well it might work if I were to
have one made similar to this one, with the exception that it would
be for a 2-rotor instead of a 3 rotor, and without provisions for a
turbo.

If I could have it made just terminating in a short, straight
pipe, I could then just attach stainless steel flexible pipe, and it
would be easy for me to try different mufflers, such as the Borla
and Burns Stainless ultra light muffler, etc.  Because it is a pusher,
I would like to have the pipes pointing toward the water pump instead
of toward the flywheel, and from there I could attach stainless flex
pipe in a 180 degree bend, then the muffler. That would fit within my
cowling pretty well.  Any idea how the expansion joints or whatever
they are on this picture were made?  I see that Burns Stainless has
inconel bends, but I don't have a source for the square inconel plates
that would mount to the engine exhaust ports. Possibly I could get
away with stainless if it were thick enough? Thanks for your opinions
and ideas. Hopefully, Ed Klepeis is monitoring.  Paul Conner

This man was big bucks. Something like $3000. I don't think you need

anything

quite that fancy. But you can call Jim Mederer at Racing Beat and ask him
where he had it made.

There is a trade off between weight and cost. .049" thick
321 SS would work great. Do you have room for a VAM with a steel tube

running

forward to a supply of cold air? If that is not possible a simple

tangential

muffler would also work as long as the exhaust pipe was not aimed directly
at the prop. If you go the square route 1/4 thick flanges would be fine.

Paul Lamar

Hi, Paul.....I have loads of room for a Vam....unfortunately, they are not

yet available, and I am in need of an exhaust very soon. (At least my
neighbors think I am in need of an exhaust/muffler).  Thanks for the info.
Paul Conner

Well Ed should be able to build a regular tangential muffler for you
in just a few days.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.