Ok Guys here goes, With all this exhaust talk nobody has mentioned

titainium.

Before everyone goes loopy on me, let me mention that I have an all Ti
exhaust on my gsxr Suzuki. While this exhaust was far from cheap,
(retail 1500 bucks,) there are some real advantages. First; Ti doesn't
corrode. It is similar to 300 series stainless in that reguard. Second;
Ti has high temperature resistance, it's actually stronger at temp.

Lastly;

it is so light IT IS AMAZING. My entire 4 into 1 exhaust system

including

the muffler weighs 7 pounds. Welds similar to stainless. The exhaust on
my bike is at least as complex as the Racing Beat turbo one if not more
so. seems like we could make a good tangential or VAM out of it for
less than the inconel systems. Tubing is available. What do you guys

think? Bill Jepson

Bill,
So what would be the cost and weight of a Vam muffler in Titanium as
compared to the Stainless Steel or Inconel (i.e. a rough cost benefit
analysis).

A question on the Ti - if it gets stronger with heat does it act like 6064
Al whereby the Al gets harder as it is artificially ages with heat, or is it
a cyclic thing and if cyclic (ie hard then soft), would that induce cracking
at welds etc.

George (down under)

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.