<<  Pretty tight bend, so I'm concerned
 > that the outside of the bend is somewhat thinner than the original
 > .049 material.  The rest of the exhaust system will be a slip fit
 > over these two pipes.The first couple of inches of the system
 > take the most abuse, and the tightness of the bends concerns me.
 > Here are a few thoughts:
 >  >>

Fabricate those pieces from flat stock, in .063 Minimum.put in a littleblast
tube for airflow. Never a problem.

Lynn E. Hanover

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.