Friend of mine had his rotten oil cooler plumbing hose fail on the
freeway. The oil pump pumped all the oil over board and the engine
seized. Only had 300,000 miles on it and it was running as
well or better than new when this happened.
If it hasn't happened to you yet just wait. Not if but when. Or you
could replace the plumbing with expensive metric to AN adapters and
expensive all AN hose and fittings.
Here is a low cost trick I came up with. Cut the swaged steel collar off
the old metric hose with a disk grinder and replace the flex hose part with AN -10.
Dash ten is a perfect fit on the metric steel hose barbs.
Preferably teflon but regular double SS braid will work for
at least another ten years. Earl sells a wheel for an ordinary copper
pipe cutter to convert it into a swaging machine. Or you could buy
two and dull the existing wheel. Earl also sells
thin aluminum collars that go around the end of the hose that are designed
to be swaged and hold the new hose tight on the old metric
steel tube plumbing. They look a little thin to me so something a bit thicker
might be better. In any event test the assembled hose to a couple of
hundred psi before you reinstall it on the car.
This sounds like a pretty good little biz to get into. Offer to overhaul
RX7 stock oil cooler plumbing.
I would not do this trick on an aircraft engine as mainly it lacks
the necessary plumbing flexibility to fit our oil cooler locations.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.