Perry Mick wrote:

Remember Paul when I had my engine rebuilt at Mazdatrix, I wanted to tap the
heater port for an AN fitting? Paul Conner did some research on this and
found that after you remove the hose bung from the engine, the hole is too
small for a 1/2" NPT tap, the tap would not leave enough meat around the
edges.  I just found out you can get 3/8" NPT to AN-10 adaptors from

http://www.anplumbing.com/shop/

steel 90 degree is part number 962211, $6.90

Perry

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.