Bulent Aliev wrote:

I need one of these trigger rings from RX-8. Don't want to cannibalize the
engine I have. Any Ideas where I can get one?
Bulent

Unbolt it and make a pattern. Then have it plasma cut out of sheet steel.
Tracy is supposed to have one on order from Mazda but you could upload
the pattern here and we could all have one made if we needed it.


Paul Lamar

OK I will trace it and send it to you, as long as it is flat and does not
have a cupped section. The 3rd generation wheels are not flat.
Bulent

This one looks flat.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.