With all the muffler ideas out there like the tuned tangential muffler,
the simple tangential muffler, the VAM and the turbo charger I have
slowly come to the conclusions that this is the only way to build a
motor
mount. You need as much clearance around the exhaust side of the engine
as you can get and this is the best way of doing it. I call it the beam
mount. The beam and the upper diagonal brace must lie in the same
plain. It must also be laterally braced under the oil pan.
Paul Lamar<<
Al Gietzen wrote:
Looks sort of like my mount.
Al
Yes it appears similar but this mount violates a few rules of the beam
mount which leads to indeterminant (not easily calculated short of a finite
element analysis) local bending loads in the tubes. Tubes A, B, C, D and E
all need to be in the same plain. The joint where tubes A, B, C and E come together
should be moved forward closer to the front motor mount beam. Not entirely
necessary as there is very little load on the front motor mount as the
CG of the engine/PSRU/prop is much closer to the rear mount. Cantilevering
tube E forward to take these loads as done here is workable. Also tube D is in the
wrong position leading to unnecessary bending loads in tubes E and C.
Also this mount needs to be diagonally braced laterally under the engine or over
to the spar from one or more sides. Currently tube bending stiffness is
relied on to do this job.
I would monitor this mount on a regular basis for cracks.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.