Subject: The only way to build a rotary engine motor mount.
From: ACRE
Date: 1/22/2004, 7:50 AM


With all the muffler ideas out there like the tuned tangential muffler,
the simple tangential muffler, the VAM and the turbo charger I have
slowly come to the conclusions that this is the only way to build a
motor
mount. You need as much clearance around the exhaust side of the engine
as you can get and this is the best way of doing it. I call it the beam
mount. The beam and the upper diagonal brace must lie in the same
plain. It must also be laterally braced under the oil pan.

Paul Lamar

Jerry Hey wrote:

Paul,  I like this motor mount.  Are you incorporating a narrower MMP?
If you recall, I  used a 20" wide MMP  for my personal  engine mount.
It worked out nicely but with this new tubing layout, it would be much
better.  I will make the new version so we can see how it looks.  If
you go for the narrower MMP generally,  it will eliminate one set up
and should  cost less.           Jerry
-- 

J-Wind Designs/Tailwind Times
3790 S. 600 W.
Albion, Indiana  46701
260-799-4507

It should work with any motor plate width. Here is an example of what can happen
if you don't use this beam type of motor mount. This, in and of itself, is
not all that bad of an idea but the rest of the diagonal tube takes up
valuable space needed for a muffler or a turbo.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.