Subject: The only way to build a rotary engine motor mount.
From: ACRE
Date: 1/23/2004, 1:51 AM


Paul, Interesting mount. Do you realize you have reinvented the P-51
engine mount? I think this is a good idea though. On the P-51 they
wanted to keep the cowl as close to the engine as possible. Exhaust
was dumped straight through both sides. The P-51 mount
was a
box section.

That's exactly what I was thinking when I saw it. This mount would be
great
 if you were to have the exhaust exit the side of the cowl. A little
harder
to have the exhaust go down and exit under the bottom of the cowl. I
would
have built my mount like this if I had it to do over again.

Brian Trubee


If the motor mount bushings are in close to the engine at the front there
is
room out side of the beam for exhaust tubes. If the motor mount bushings
are moved outboard with a Schertz beam or wide motor plate there is room
inside the beam for exhaust tubes.

Paul Lamar

Ernesto Sanchez wrote:

Hi Paul,
    Would the beam engine mount work if the top firewall to engine mounting
points are out further than the bottom firewall mounting points?
Thanks,
Ernesto

Sure! No problem as long as all the tubing pieces lie in one plane.
It is then more important that the rubber bushing mounts be supported
laterally. 

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.