Subject: The only way to build a rotary engine motor mount.
From: ACRE
Date: 1/23/2004, 12:24 PM


With all the muffler ideas out there like the tuned tangential muffler,
the simple tangential muffler, the VAM and the turbo charger I have
slowly come to the conclusions that this is the only way to build a
motor
mount. You need as much clearance around the exhaust side of the engine
as you can get and this is the best way of doing it. I call it the beam
mount. The beam and the upper diagonal brace must lie in the same
plain. It must also be laterally braced under the oil pan.

Paul Lamar

Paul,  for the Tailwind and RV types,  can the tube  that runs from the
front bushing to upper end of the gear receiver be eliminated?  The
lateral bracing under the engine should should be sufficient,  I think.
   Jerry

J-Wind Designs/Tailwind Times
3790 S. 600 W.
Albion, Indiana  46701
260-799-4507

No absolutely not. That is how Steve Whitman took the high fore and aft
bending loads generated in the landing gear and fed them back into the fuselage
structure. First the loads go forward into the apex of the two motor mount
tubes and then back along the tubes into the fuselage. One must always
think about the load path.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.