Subject: The only way to build a rotary engine motor mount.
From: ACRE
Date: 1/23/2004, 8:13 PM


Paul,
 What is the current thinking about gusseting the tube intersections? Some 
of the intersections seem like a natural for a lightweight outside tangent gusset.
 Relitave to our discussions on engine mounts I saw a engine mount recently 
that used threaded ball-end connections to firewall mount plates. Unfortunatly 
I can't remember what it was on. The obvious fact is that the mount HAD to 
be properly triangulated! This was the check we were talking about. The 
mount looked very nicely done. They used a long "V" notch to weld a solid 
end into the tube with internal threads.

Bill Jepson

Gussets are not really needed if the mount is designed right.
However mild steel gussets seem to yield before they cause stress concentrations
in the 4130 tubes.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.