Subject: Wanted pictures or drawings RV6A motor mount.
From: ACRE
Date: 1/23/2004, 12:24 PM


Ernesto Sanchez wrote:

Anybody have any pictures or drawings of an RV6A nose dragger motor
mount?

 One page in two parts.  Sorry they are big.  I wanted them to be clear.
Ernesto


Thanks Ernesto. This is the one I needed.

Paul Lamar

Now I have to figure out how to make tubing brackets bolted to a 13B that
will adapt to this dynafocal motor mount. I must find taped bolt holes here and
there on the block not designed for motor mount use that will accept the
loads. It is easy for Lycoming as they just cast the brackets on to 
the crankcase. No such luck for rotary engines as their mount system
is entirely different. We have been struggling with these motor mount
problems for going on six years in April. At this point in time
the beam mount discussed recently looks like the best overall solution.


The trouble with rubber bushings is they are basically 
ball joints. They are not designed to transfer bending loads. If 
you pass a bolt through a rubber bushing the bending loads
on the bolt are real high. 

The second attachment below is a simple 2D illustration of the 
problem. There are three ways of supporting, from the engine, 
just two of the four mounts required. The simple triangle, the triangulated
bay and the cross brace in space frame speak. None are easy or simple.
You could also use brackets hogged out of massive blocks of aluminum
billets or extrusions.

At one time we discussed, at length, casting a new front cover with 
the Dynafocal mounts cast in. That got nowhere. Too complicated
and too expensive.

It is much much easier and simpler to forget the Lyc dynafocal mount and design
a proper beam mount from scratch. In this case that is not an option as
the plane is already flying. 

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.