Subject: RV-10 mount was Re: RV6a, RV8a beam type motor mount.
From: ACRE
Date: 1/27/2004, 10:59 PM


     The yellow parts are left over Van's parts. The rest of Van's
     motor mount is cut away and discarded. The green diagonal tubes
     going down to the nose gear leg socket take most of the download from
     the engine and feed it directly into the landing gear.
     The rear motor mount could be a compression  strut with rubber
ball joints
     down to the same point. Not shown.

Looks good Paul,
This is exactly what I was thinking of. I believe this will be a
preview of the
RV-10 mount as well. Bill Jepson


Regarding the RV-10 mount, I was talking to an RV-10 builder here in town a
couple of days ago and was told a very endearing rumor.  Apparently Van's
is looking into a mount for the Continental O-470/520 engines.  If this is
true, these mounts would lend themselves to an easy 20B adaptation.  The
Continentals use a bed mount as opposed to the Lyc's cantilever mount.

Mike McGee, RV-4 N996RV, O320-E2G, Hillsboro, OR
13B in gestation mode

Might help but looking at my C182 O-470 bed mount mount there still might be 
a few problems.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.