Subject: RV-10 mount was Re: RV6a, RV8a beam type motor mount.
From: ACRE
Date: 1/28/2004, 11:02 AM


     The yellow parts are left over Van's parts. The rest of Van's
     motor mount is cut away and discarded. The green diagonal tubes
     going down to the nose gear leg socket take most of the download from
     the engine and feed it directly into the landing gear.
     The rear motor mount could be a compression  strut with rubber
ball joints
     down to the same point. Not shown.


Looks good Paul,
This is exactly what I was thinking of. I believe this will be a
preview of the
RV-10 mount as well. Bill Jepson

Regarding the RV-10 mount, I was talking to an RV-10 builder here in town a
couple of days ago and was told a very endearing rumor.  Apparently Van's
is looking into a mount for the Continental O-470/520 engines.  If this is
true, these mounts would lend themselves to an easy 20B adaptation.  The
Continentals use a bed mount as opposed to the Lyc's cantilever mount.

Mike McGee, RV-4 N996RV, O320-E2G, Hillsboro, OR
13B in gestation mode

A> Might help but looking at my C182 O-470 bed mount mount there still might be
A> a few problems.

A> Paul Lamar


Don Dunbar wrote
 I have made 3 engine mounts now and it is my view not to play with
 converting or trying to adapt any other mount. There is about 20
 hours in a mount from start to finish once you have the firewall
 pattern.
 If you have a mount that was made for your aircraft use that to mark
 a flat surface replicating your firewall. The tip is to use a
 material that will not burn during welding or use large insulators.
 Next step is to position the tube engine mounts that support the
 Barry or Lord 2 piece mounts, this structure needs to be stayed well
 with diagonals that dont interfere with the tube engine mount. When
 you have done this cut and fit all tubes struts. With a 4" grinder
 with a 1/16th cutting blade it is like cutting butter, hence the name
 of the blades are called butter cutters which work very well on fibre
 glass. After this I would take it to a good tig welder to complete.
 The end result is that the end connection will be structural right
 and all force are targeted at the base or intersection of the bolts
 and fixing points
--
Best regards,
 Don                            mailto:ddunbar@echidna.id.au

I totally agree. Good job Don of explaining the process.

Also check with Jerry Hey. He has a rotary engine 
motor mount jig  that can be adjusted to fit any firewall bolt pattern.
A good jig is not cheap to make.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.