Subject: RV-10 mount was Re: RV6a, RV8a beam type motor mount.
From: ACRE
Date: 1/29/2004, 2:12 PM


   I am thinking of having Danny make some more MMP's.  Do you want to
revisit that design?   I would like to make just one size (width) that
would fit every situation.  With the new tube layout,  that should be
possible.   Also,  what is happening with the cast bell housing?
That might put the MMP out of business if  it becomes available.  Are
you looking for someone to finish the castings?  Danny would be a good
choice.

I know I have said a lot of the above before but things have progressed
  more slowly than anticipated.
    Jerry


Jerry Paul and Everyone,
Butch has been hard at it but has also been interrupted by his employer and
dragged him off the project - a number of times.
I suggested to him we had better get it finished and we have been discussing
the difficulties with the 6 O'clock starter position.
Butch is very pedantic with his drawings, but said he will have the final
done shortly for any further group suggestions.
But I got to tell you we have done this thing to death, there a couple of
ways to do things but usually only one way to suit all installations, which
makes things a compromise, which is definitely the case with the 6 O'clock
starter position.
George (down under)

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.