Subject: New rotary powered airplane. Investors wanted.
From: ACRE
Date: 1/31/2004, 2:56 PM


I call this traction propulsion. This consist of two large
diameter
tubular rotating carbon fiber spars driving a thin rubber belt
with a lot of long thin aluminum hat section cleats attached.

It becomes 100% efficient at high speeds and skin friction drag
on the lower wing skin is eliminated. Normal flaps and ailerons
are used. The propeller and PSRU are eliminated.

The 13B turbo rotary engine transversely  buried in the fuselage
drives both rotating spars with a long cog belt.

I am setting up a web site and I am looking for investors.

Paul Lamar


Harrison Young wrote:

So you're going to run a conveyer belt at 200+ MPH? I look forward
to seeing
that :)

Harrison Young

There are a few technical problems to overcome but nothing your money
can't fix.

The first flight is scheduled for 2nd quarter 05.

Paul Lamar

Hi Paul,

You did neglect to give the specs.  Lack of any actual test data (or
logic) shouldn't be any hindrance.  As an early investor, I would like
to suggest the following:

large 4-place cabin
1100 lbs empty wt.
3000 lbs gross wt.
1900 lbs useful load
350 mph cruise (or should that be kts.)
4000 fpm climb @ 120 mph
6 gph fuel consumption at cruise

Did I forget anything?  How did I arive at these numbers?  Well, that's
about what I would like to see! :)  Should I be more optimistic?

Bob White

http://www.bob-white.com
N93BD - Rotary Powered BD-4



Yeah but!

Now you are just at the concept and FINACING phase and you already got it
all wrong!
You know this half-low-wing layout completely deletes any more advanced
possibilities.

Put the wing ALL the way on the bottom, and:

a) Eliminate the landing gear and use your caterpillar drive also on the
ground (you may need some SRU, but Tracy is a specialist on the list here)

b) ...this also will help in offroad  landing spots, general off-roading, in
winter, to drive to town from the airport, etc. (for electronic speed and
sequential tractor control also contact Tracy)

c) ...maybe you should contact caterpillar, the guys with the big yellow
gear. They might loan you one and all you have to do is to replace
everything with carbon fibre and slap on some wings, ...done! They figured
the drive out long time ago! Just got to speed it up (Tracy again, he might
be wizard with SIU's also....)

d) My contribution to the development, you can pay me when your first big
checks arrive!

Thomas J. :)

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.