Is your rotary cooling system boiling over Binky?
No problem. Just run pure ethylene glycol!!!
This blew me away when I saw this. I had no idea
pure ethylene glycol boiled at 380 F.
This does not work for a piston engine as it erodes the
aluminum surface of the combustion chamber. For that reason
Allison gave up on the idea running the cooling system at 300 F
and pure ethylene glycol. Ethylene glycol does not transfer heat
as well as a water ethylene glycol mix. In a PISTON ENGINE this
causes the combustion chamber to run too hot, erode and detonate
The Wankel rotary has the opposite problem. The combustion chamber
runs too cool and is lined with steel.
In theory one of the advantages is.. it is possible to use
a smaller rad due to the higher delta T. Another is.. less energy
loss to the cooling system and better BSFC. Less fuel burn
for a given HP.
Be careful doing this. There could be all sorts of unwanted
side effects.
Paul Lamar
Paul, Not to mention that e. glychol is fast becoming a controlled substance.
The stuff actually IS a hazard so the eco-weenies might have a point on this one.
I don't remember what the new material OK'ed for anti-freeze/coolant. Ken
Wellter was saying he uses one of the new "approved" coolants, don't
remember what the chemical composition is.
Bill Jepson
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.