Subject: Major Break through in rotary engine cooling.
From: ACRE
Date: 2/3/2004, 8:06 PM


 In this case none of the things you mention are limiting the temp we can run
 the rotary.

I have noticed when overheated, that there is a tendency to snap off sections
of the front cast iron. Starting with a crack through the vertical oil
gallery. It won't get much hotter after that because it seizes for lack of oil.

Better under 220 tops on the coolant. And not over 170 for best power. The oil is
under 160 for best power.

Lynn E. Hanover


Are those the 12A front cast iron end housing? At what temp do they crack?

If it boils over while in the air you are coming down very soon.
You can run it cooler if you wish but raising the boiling temp gives
that much more margin for error.

Paul Lamar

Is the reheat on the cold side of the engine shut off?
Also at what HP level is that? It is kind of hard to believe that
a 12A front end housing cracks around the 150 HP per rotor level while 
the 13BREW and 20B are pushing 400 HP per rotor in drag racing. Abel Ibbarra 
told me his biggest problem is with rotor bearings running at 11,000 RPM and up.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.