Subject: Mazda Speed RX8 - Motor Trend
From: ACRE
Date: 2/3/2004, 4:42 PM

Vance W Jaqua wrote:

Paul - the article from Road and Track - They say your rides too soft
Vance

Motor Trend or Road & Track?

There are some boy racers journalist out there where nothing is ever stiff enough.

Also they did not drive it on the problematic southern California freeways.
Freeway hop is not necessarily caused by high spring and roll bar rates.
You can have a stiff chassis and not have freeway hop. Herb Adams
proved that back in 1973 with the original Trans Am Firebird.

As far as the structural stiffness is concerned they probably saw my 
diagonal brace suggestions on here :)

What month was that article published in? Who was the author?

Paul Lamar

Old message on the subject.
*************************************************
Subject:       Blown 3 Rotor engine torsional stiffness.
   Date:       Thu, 18 Dec 2003 09:31:52 -0800
   From:       ACRE <rotaryeng@earthlink.net>
 


How about a large properly triangulated space frame using steel tubing
surrounding the entire engine? Front and rear motor plates. That would
give you a front chassis structure to hang the front


snips....

BTW the RX8 chassis is flawed in this regard. One or two light weight 
diagonal braces under the tunnel and they could reduce the chassis weight
in other places. Probably the rocker panels.
Don't get me wrong. The RX8 back bone frame is remarkably stiff as is.

Paul Lamar
****************************************************************
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.