This blew me away when I saw this. I had no idea
pure ethylene glycol boiled at 380 F.
The Wankel rotary has the opposite problem. The combustion chamber
runs too cool and is lined with steel.
In theory one of the advantages is.. it is possible to use
a smaller rad due to the higher delta T. Another is.. less energy
loss to the cooling system and better BSFC. Less fuel burn
for a given HP.
Be careful doing this. There could be all sorts of unwanted
side effects.
Paul Lamar
Let's see; lower flow rate, poor conductivity (higher thermal stresses
due to temperature gradients in the engine) higher pumping power, higher
rotor temp, decreased life of side seals, more heat to the oil (higher
oil temp). What have I missed?
Al
All true Al but nothing that can't be accommodated with 500 F synthetic oil
in the sump, two cycle oil mixed with the fuel and all 500 F teflon encapsulated
O-rings. These material developments make what were once un-solvable problems in the
1930's now solvable. Very typical of many old ideas that have been
resurrected.
In this case none of the things you mention are limiting the temp we can run
the rotary. Boiling is the current limiting show stopper condition. Allison
was well aware of all these factors. The limit then was the combustion chamber temp
and not any of the things you mentioned.
Perhaps if the boiling limit was 380 F something else would then become
the critical rotary engine operating temp limit.
Paul Lamar
Ethylene glycol when mixed with water drastically reduces the freezing
temperature, but I remember reading that with pure EG, the freezing
temperature again increases. Just something to be aware of if you do
this. Freezing temp is still lower than pure water.
From a websearch:
Pure ethylene glycol has a freezing point of about +9°F, Inhibited
glycols usually contain a small proportion of water (2 - 4%) and hence
would not be expected to freeze unless exposed to temperatures somewhat
below 0°F.
--
Perry Mick
Yes it does.
I uploaded the chart Perry. I guess you missed it. Here it is again.
You will just have to use a block heater in the winter time :)
Paul Lamar
You know most liquids contract when they freeze, but water is different
and expands when it freezes. I wonder if EG contracts when it freezes?
Maybe it wouldn't do (as much) damage to the engine if that was the case?
--
Perry Mick
http://www.ductedfan.com
Good question. I don't know the answer to that. Ken mentioned that propylene
glycol turned to slush at low temp. Some of you guys up north where it is
minus 20 F get some Prestone and put it in a bottle outside over night.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.