Subject: Major Break through in rotary engine cooling.
From: ACRE
Date: 2/4/2004, 1:01 AM


<< Is the reheat on the cold side of the engine shut off?
 Also at what HP level is that? It is kind of hard to believe that
 a 12A front end housing cracks around the 150 HP per rotor level while
 the 13BREW and 20B are pushing 400 HP per rotor in drag racing. Abel Ibbarra
 told me his biggest problem is with rotor bearings running at 11,000 RPM and
up.
  >>

The power out has nothing at all to do with overheating at the 300 degree
level. There just won't be much HP left to measure at 300. Detonation and then
preignition and then silence.

Lynn E. Hanover

How do you know? Have you ever run an engine on the dyno with 300 F
water temp? Allison ran some engines at 300 degrees F in the early
1930's  and they got plenty of power without detonation. So too did 
Continental. The metal temp in the combustion chamber runs 500 F and 
is little affected by lowering the water temp from 290 F to 250 F.
See the chart I just uploaded. The HP was not affected at all. 

Detonation depends on the charge temperature and not the water temp.
Also it depends on a lot of other things. Mixture for example.
If the charge is cool enough it won't detonate. If you are using an aluminum
intake manifold as I suspect you are  the charge temp will be higher.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.