Hi Mr. Lamar... I saw the intake parts you developed on Tracy Crook's
website. I was wondering if you can tell me anywhere I might see

pictures

of the manifold and runners installed. I'd like to see some photos of

a

running system. Thanks very much for your time and attention.

Best regards,
Ben Ridgdill

There are a bunch in the works but I don't think anybody is running
a complete set yet. It has only been a few months. Here are some
pictures of
Bill Schertz set up. Ed Anderson has been flying just the lower manifold
part for
at least four months. I should be only weeks away myself on the dyno
engine.

Paul Lamar

-"Joe Hull (Pilgrim Technologies)" wrote:

Paul, How much do you charge for those manifolds?

Thanx,
Joe Hull- 

The lower sections are $180 and the bell mouth injector holders are $45
each. Plus $15 per shipping event to the US.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.