What about limp-home modes for a rotary/aircraft instalation, like the
Cadillac/Northstar, which uses fuel to cool the cylinders, by not firing
them in a certain sequence. When this was new, I read in a German car
magazine, that 2 reporters actually tested this feature, right down
"Death
Valley" - they would actually drain the coolant and just drive off. All
they
noticed, was a warning light and lower power than with coolant. Is there
a
simple way (from a programming point of view) to incorporate something
like
this in e.g. Tracy's engine controllers and would it actually have any
benefit for the rotary?
I am thinking of potential problems with the unburned mixture in the
(very)
hot rotary exhaust - might get a real "afterburner" there! But it might
work
with just cutting out every other injection cycle....
Thomas J.
Yes. The rotary does not run well on one rotor. Firing every other
time
might work.
Paul Lamar
This sounds like an excellent idea to me. You could even build into the
engine controller the ability to run VERY rich on the injection cycles which
won't be ignited, while maintaining a normal mixture on the cycles which
will be ignited. Of course an explosion in the exhaust system every other
revolution might make this less attractive. This is something which could be
easily and thoroughly tested on Paul's new Dyno. We should get Tracy to look
at this immediately (before the competition beats him to it :)
Harrison Young
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2003 All world wide rights reserved.