Subject: Major Break through in rotary engine cooling.
From: ACRE
Date: 2/5/2004, 7:24 PM


They then
continue on their way with no permanent engine damage. It
would be
interesting to hang around out there and
gather samples.
Paul Lamar

Paul Lamar
Interesting thought Paul, I wanted to mention
again that many scantioning bodies don't allow
EG in race cars. I believe NASCAR and some others
do allow the NPG coolant which can be cleaned up
with typical grease sweep materials. Jon, your
radiator comments show that you were not quite
getting what Paul was intending. The INTENTION
was to run a typical temperature of around 250°
with protection up to 300°+. At the elevated
temperatures the delta T would be higher therefore
requiring a smaller radiator. If the delta
difference would improve the overall rejection
or just get it back down to normal with pure EG
is the question. I think everybody here knows
this but I will restate it, NOTHING has been
found that PRACTICALLY cools better than pure
water. The chemical solutions are for better
operating under special conditions. Bill Jepson


Thanks for catching that point on the radiator size Bill. I was about
to do it myself. We need a plot of the cooling parameters of EG/water
verses mixture
ratios plotted against the increase in boiling temp.

I have overheated all six  rotary powered  cars I have owned many
times with the exception of the RX8. Only the 1972 12A RX2 required
overhaul because it had neoprene coolant O-rings instead of silicone.
I expect it got new rotor housings but I don't recall. The Cosmo oil
O-rings went out but all that happened was oil would leak down past
the rotors and cause the engine to smoke heavily when it was started
up.

Paul Lamar


The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2003 All world wide rights reserved.